Harbor-freight-tools CENTRAL MACHINERY 44846 Uživatelský manuál

34 INCH FLOOR RADIALDRILL PRESSModel44846ASSEMBLY AND OPERATING INSTRUCTIONSVisit our website at: http://www.harborfreight.com Read this material befo

Page 10SKU 448463. With the screwdriver still in place, loosen the (inner) Hex Nut (7) until the Cap Spring notch disengages from the Spring Retainer

Page 11SKU 44846TroubleshootingSYMPTOM POSSIBLE CAUSE SOLUTIONDrill bit burns orsmokes- Incorrect spindle speed- Dull drill bit- Drilling too slowly-

Page 12SKU 44846 Item # Description1 Self-tapping Screw, 4.22 No-Volt Switch3 Screw, Pan Hd., M5x124 Switch Box5 Screw Set, Special6 Nut, Hex7 Nut, H

Page 13SKU 44846Pulley and Spindle Assembly Parts List Item # DescriptionA1 V-belt, M58A2 Pulley NutA3 Spindle PulleyA4 Insert PulleyA5 Retaining Ring

Page 14SKU 44846Base and Table Assembly Parts List Item # DescriptionB1 ColumnB2 RackB3 Screw, M10x12B4 Column SupportB5 Hex Bolt, M10x40B6 BaseB7 Tab

Page 15SKU 44846LIMITED 1 YEAR / 90 DAY WARRANTYHarbor Freight Tools Co. makes every effort to assure that its products meet high qual-ity and durabil

Page 2SKU 44846SpecificationsSave This ManualYou will need the manual for the safety warnings and precautions, assembly instructions, operating and mai

Page 3SKU 448465. Do not force tool. It will do the job better and more safely at the rate for which it was intended. Do not use inappropriate atta

Page 4SKU 44846replacement parts. Use of any other parts will void the warranty. Only use accessories intended for use with this tool. Approved access

Page 5SKU 448468. When finished with the Drill Press, always press the Switch to the OFF position.9. Do not mount (or adjust) the workpiece on the Dr

Page 6SKU 448465. Install the Table Support (B7), with attached table Arm (B14), over the Column (B1) and slide it down. Engage the gears onto the Ra

Page 7SKU 44846a wrench. - Rotate the Table until it is square to the bit. - Retighten the Hex Bolt (B12).OperationWarning: Avoid personal injuries. B

Page 8SKU 448465. To return the Head to the 90 degree position, do these procedures in reverse.Moving the Head Horizontally1. Loosen the left-side C

Page 9SKU 448464. Push the Motor (22) backward and hold. Retighten the Thumb Nut.Note: To test the proper belt tension, push in on the center of each