Harbor Freight Tools xenon Advance Timing Light Manuál stáhnout pdf (Strana 8)

Page 8 For technical questions, please call 1-800-444-3353. Item 40963

Small Engine Timing

1. The Timing Light can be used to

test the timing on any combustion

engine that utilizes an impulse or

magneto ignition, such as motorcycles,

lawn mowers, or outboard motors.

If the product does not have a 12 V

battery then use an external battery.

2. Connect a ground from the external

battery’s Negative Post to the engine.

3. Connect the red clip of the Timing light

to the Positive Terminal of the Battery

and the black clip to the Negative

Terminal of the Battery. Connect the

Spark Plug Clamp of the Timing Light

to the spark plug wire with the arrow

pointing towards the spark plug.

Rotary Engine Timing

1. Connect the red and black power leads

to the battery. Connect the Spark

Plug Clamp to the wire for the leading

spark plug on the front rotor housing.

Figure 5

2. Start engine and run it at idle speed.

3. Aim the Timing Light at the timing

indicator pin of the front cover.

Figure 6

LEADINGTRAILING

4. Loosen the distributor locking

nuts and rotate the leading side

distributor body until the timing mark

on the eccentric shaft pulley is in

line with the timing indicator pin.

5. Tighten locking nuts and recheck timing.

6. Repeat this process to set the

trailing side distributor timing.

1 2 3 4 5 6 7 8 9 10 11 12

Žádné komentáře

Harbor Freight Tools xenon Advance Timing Light Manuál Strana 8