Harbor Freight Tools 3733 Uživatelský manuál

4” TILE SAWWITH PVC TRAYModel 03733ASSEMBLY ANDOPERATING INSTRUCTIONS3491 Mission Oaks Blvd., Camarillo, CA 93011Visit our Web site at: http://www.har

8. Place the workpiece to be cut against the Parallel Rip Fence (part #7), and slowlyfeed the workpiece into the spinning Tile Saw Blade (part #36).

slowly feed the workpiece into the spinning Tile Saw Blade (part #36). (See Figure B.)2. When finished making the angled cut, turn the Power Switch

PARTS LISTPart # Description Qty. Part # Description Qty.1 Table 1 21 Angle Gauge 12 Handle 1 22 Bench Stop 23 Handle Base 2 23 Motor Holder (Top) 14

SKU 03733 PAGE 2PRODUCT SPECIFICATIONSItem DescriptionElectrical Requirements 120 Volt / 60 Hz456 Watts / 4,480 RPMMaximum Cutting Size Capacity 12” L

4. DO NOT USE THIS PRODUCT IF UNDER THE INFLUENCE OF ALCOHOL ORDRUGS. Read warning labels on prescriptions to determine if your judgement orreflexes a

must understand that common sense and caution are factors, which cannot bebuilt into this product, but must be supplied by the operator.SPECIFIC PRODU

6. KEEP ALL SAFETY GUARDS IN PLACE, IN PROPER ADJUSTMENT, AND INPROPER ALIGNMENT.7. REDUCE THE RISK OF ACCIDENTAL STARTING. Make sure the PowerSwitch

18. FEED THE WORKPIECE GRADUALLY INTO THE TILE SAW BLADE(part #36) WHEN CUTTING. Do not force the machine to remove material fasterthan it was design

PRODUCT DESCRIPTION1. The Tile Saw features a built-in water supply that keeps its Tile Saw Blade cool,reduces dust and debris, and is easy to clean.

4. Remove the old Tile Saw Blade (part #36), and replace it with a new Tile SawBlade. NOTE: Make sure to install the new Tile Saw Blade with the arro

To Make Straight Cuts:1. Remove the Screw (part #16). Then, remove the Table (part #1) from the TileSaw unit. (See Figure C.)2. Fill the Body (part