Harbor Freight Tools 18 Volt 1/4 in. Cordless Impact Driver Manuál Strana 9

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 12
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 8
Page 9
For technical questions, please call 1-800-444-3353.
Item 61424
SAFETYOPERATIONMAINTENANCE SETUP
Operating Instructions
Read the
ENTIRE
IM
P
ORTANT SAFET
Y
INFORMATION
Y INFORMATIONY
section
at the beginning of this manual including all text under
subheadings therein before set up or use of this product.
Tool Set Up
TO
P
REVENT SERIOUS INJUR
Y
REVENT SERIOUS INJURYREVENT SERIOUS INJUR
FROM A
Y FROM AY
CC
IDENTAL
O
P
ERATION:
Make sure that the Trigger is in the off
-
position and remove
the
Battery
P
ack before adjusting tool or installing accessories.
C
harging
1.
The Charger (Item 68420) and
Battery
Pack
(Item
68413)
are sold separately.
2.
Refer to the 68420 Charger manual for
important safety warnings and proper
instructions on Battery charging.
WARNING!
Do NOT use a different charger
or battery pack to power this tool.
Workpiece and Work Area Set Up
1.
Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
2.
Secure loose workpieces using a
vise or clamps (not included) to
prevent movement while working.
3.
There must not be objects, such
as utility lines, nearby that will
present a hazard while working.
General Operating Instructions
1.
Make sure that the Trigger is in the
off
-
off-off
position, then
attach the Battery Pack
.
2.
Insert an appropriate impact-rated
accessory (sold separately) into the driver.
3.
Use the Direction
Switch to
select a rotation direction.
Press the Direction
Switch to the right for
counterclockwise operation (loosening).
Press the Direction
Switch to the left
for clockwise operation (tightening).
Center Direction Switch to lock Trigger.
4.
Squeeze the Trigger to operate the tool.
Tighten/loosen the fastener(s) as desired.
5.
To prevent accidents, turn off the
tool and
remove its Battery Pack
after use. Clean, then store the tool
indoors out of children’s reach.
Note:
The amount of actual torque will vary
depending on the cleanness and condition of
the threads and other factors. If tightening
critical components, chase threads before
assembling components and check the
actual torque applied to the fastener with a
mechanical torque wrench (not supplied).
Zobrazit stránku 8
1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře