
Page 29For technical questions, please call 1-888-866-5797.Item 60794
6. Press the ENTER button to wait for the Menu to appear.
Diagnostics
1/2
OBD2/EOBD
ABS
?
Figure 5.2
7. Select OBD2/EOBD and wait for a few seconds; a sequence
of messages displaying the OBD II protocols will be observed
on the display until the vehicle protocol is detected.
• If the Scan Tool fails to communicate with the
vehicle’s ECU more than three times, a “LINKING
ERROR!” message shows up on the display.
a. Verify that the ignition is ON
b. Check if the Scan Tool's OBD II connector is
securely connected to the vehicle's DLC
c. Verify that the vehicle is OBD II compliant
d. Turn the ignition off and wait for about 10 seconds. Turn the
ignition back to on and repeat the procedure from step 5.
• If the “LINKING ERROR!” message does not go away,
have the tool inspected by a qualified technician.
Komentáře k této Příručce